M-Spec Mirror Caps
Sculpted M‑inspired mirror upgrade.
These replacement caps reshape your mirrors with German motorsport‑inspired design and real carbon veneer. A lightweight ABS core preserves factory clip strength, while a deep‑gloss/matte clear coat shields the weave from UV and road grit.
- Wet‑laid 2×2 twill carbon over OEM‑grade ABS core
- Perfect clip alignment
- UV‑stable finish — no flake
- 20‑minute swap; plastic trim tool recommended (not included)
- Finish options: Gloss · Matte · Honeycomb · Forged (custom)
Pair them with carbon side‑camera covers for a unified, full CF look.
Fitment
Install
Tools — 2 × nylon trim pry tools, microfiber towel, 70 % IPA, nitrile gloves (optional).
Prep — Fold the mirror column inward via the center touchscreen. Wipe the painted housing and cap seam with IPA; dry.
Remove OEM caps
1. Insert Pry 1 at the lower inside corner until the first clip releases.
2. While Pry 1 holds the gap, slide Pry 2 along the bottom edge; work left-to-right until all lower clips pop.
3. Move Pry 1 to the top outside corner; twist gently to free the upper clip.
4. Lift cap straight off—do not pull toward the glass (risk of scratching).
Inspect — Ensure all six OEM clips stayed on the cap, not in the housing. Remove any debris and/or broken clips.
Install your Bullet™ M-Spec
1. Align top tabs first; seat them into the factory slots.
2. Press downward until both upper clips snap.
3. Work bottom edge from center outward, pressing until each clip audibly locks.
4. Run a fingertip around the perimeter; the seam should be flush and even.
Check — Cycle the mirror motor through full range; cap must stay seated and not rattle. No adhesives required.
If it rattles, one of the six OEM clips is still on vacation—press again until it clicks.
Re-verify after the first drive to confirm all clips remain engaged.
Returns
Window — 30 days from delivery. Start a return at bulletcarbon.com/returns to receive your RMA#.
Condition — Parts must be unused, liner intact, and in original box. Bundles return as a full set. Adhesive installed/damaged clips = non‑returnable.
Shipping — We email a prepaid label (USA). $14 is deducted from your refund **unless the item is approved as defective**. International customers ship at their cost; defects get a shipping credit.
Refund — Store credit lands the moment the scan hits the carrier. Back‑to‑card on request (3 % processing fee). 15 % restock if packaging is missing or damaged.
Defects — Free replacement or full refund (including shipping) within 60 days when photo proof shows a manufacturing issue. Zero restock fees.
Need Help?
Ping **support@bulletcarbon.com**
— Real humans, fast replies.
Goal — Keep you stoked, not broke.
Choose options